Small Leak? Tips On How To Know What You Can Do Or When You Required To Call A Plumbing Professional

If you're a home owner unfamiliar with plumbing, you're probably familiar with the experience of being charged an arm and a leg for what seems like a simple plumbing repair. If you'd like to avoid this experience again, read on for some advice and tips on how to fix your own plumbing.

Before starting any plumbing project be sure to turn off the main water supply. Water damage can be one of the most expensive things to repair. To minimize damage turn the main water supply off as well as any shut off valves near where you are working. This will save a great deal of hardship later on.

On very cold winter nights, allow your faucets to trickle slightly, especially if your pipes are located in a crawlspace. The running water prevents the pipes from freezing as quickly as they would otherwise. You can catch the water and use it for other household needs to prevent wasting it.

To avoid clogs, pay attention to what you flush. Sanitary napkins, thick toilet paper and baby wipes should never be flushed. These items can expand and cause a clog, or get caught on a pipe. Instead, dispose of them in a sanitary way that does not involve flushing them down the toilet.

Set the temperature on your hot water heater to a temperature that does not exceed 120 degrees. This helps to save energy and prevents the water from becoming too hot and potentially scalding someone in your household. Older models that do not have a temperature setting should be set on Medium.

Watch how your toilets are flushing. If you have to jiggle the handle or if it takes too long, you might have to repair some toilet parts. Replacing these parts early may help you to save on your water bills and will save you from more expensive repairs at a later date.

Install screen traps or drain covers on all of your sinks and tub drains. Most home plumbing calls are about clogged pipes. These can be caused by debris, especially hair, washing down the drains. Putting in a trap means that you can clean this debris off before it ends up in the pipes.




Everyone in your home should know where the main water shut off valve is. By knowing where to find this valve, you'll be able to shut off the water in the event a pipe bursts, a bathtub or toilet overflows or any other emergency that requires you to turn off the water.

If you have an underground leak in your pipes, it is possible to detect the leak before digging. Today's leak detection equipment is very sophisticated and modern, allowing technicians to detect and pinpoint exactly where leaks are before they go about trying to fix them with professional grade equipment for you.

Try to limit the amount of hair that goes down your drains. Hair can become tangled up in the pipe and end up blocking up the them, preventing water from flowing smoothly. Buy a cheap screened drain cover to put over your drain to stop any hair from going down and clean it off regularly.

One way to prevent water heater problems is to turn down the heat. As long as the water is still as hot as needed for showers and washing dishes, turning it down won't hurt anything, and will extend the life of the heater. Holding very hot water can corrode the inside.

There are two ways to get a clean out fitting out. First, try using a chisel with a hammer to get the fitting loosened. Your second option is to simply chisel through the plug itself.

If water is flowing out from where your meter is located, a professional is required to come out and fix the leak. If your water bill goes up, this is most likely because the leak is on the house side of the water meter. You will need to get a professional to come out and fix the leak.

Repair a leaky faucet as quickly as possible. Most leaky faucets are caused by a worn or damaged seal, which can easily be replaced, but you need to attend to it quickly. A slow leak can waste up to 20 gallons of water per day, costing a lot of money in the long run. If the faucet is really old, sometimes it's worth replacing the entire fixture.


Check check this site out in your home. If your home has the flexible gray polybutylene water pipes, you need to have a plumber come out and assess their condition. These types of pipe are prone to failure and can lead to very costly repairs if they have a failure within your home.

Make sure that when you are doing any home improvements to your plumbing that they are done up to the building codes in your area. The building codes are there to protect people from being scalded by hot water, trap harmful sewer gas from entering the home, and ensure plumbing is done properly before finishes are applied.

Many people complain of low water pressure. While there are several things that can cause this, one must not be overlooked when starting your investigation. What kind of pipes do you have? If your piping is galvanized, you are better off just replacing your piping which will eliminate the issue.

To keep your drains moving freely and free from gunk and buildup, pour a half cup of baking soda followed by a cup of white vinegar down each drain once a month. The foaming action helps to push stuck substances through the pipe, while the vinegar neutralizes odors. You can follow this solution with a kettle of boiling water for extra cleaning power.

So, now do you see why plumbing is such an exciting endeavor? Creating your own skills, learning to take care of your system, and being able to fix it yourself to save money is very exciting. The tips above should have created a good foundation for you to build upon and do your own plumbing jobs easily.

Leave a Reply

Your email address will not be published. Required fields are marked *